Guide · Homeowners · 4 min read · Updated 17 November 2026
How Much Does Basement Waterproofing Cost in the UK?
Short answer
Most UK basement waterproofing costs £90–£160 per m² for a cavity drain membrane or £70–£130 per m² for cementitious tanking. A sump pump system adds £1,800–£3,500. A typical small cellar of 20 to 30 m² made habitable to Grade 3 usually comes to £8,000–£18,000 all in. A survey at £150–£350 fixes the scope and gives you one written price.
Typical basement waterproofing prices in 2026
Waterproofing is priced on the area of wall and floor treated, plus fixed items such as drainage channels, the sump chamber and pumps. The figures below are guide prices for supply and fitting by a specialist. They assume normal access down an internal stair and walls in average condition. Boarding, screed, plastering and decoration on top of the waterproofing are usually priced as separate lines, so check what a quote includes before comparing two firms.
| Item | Guide price | What it covers |
|---|---|---|
| Damp and water ingress survey | £150–£350 | Inspection, moisture readings and written report |
| Cavity drain membrane | £90–£160 per m² | Membrane, sealing and perimeter channel |
| Cementitious tanking | £70–£130 per m² | Preparation, fillets and multi-coat slurry |
| Sump pump system | £1,800–£3,500 | Chamber, twin pumps, alarm, battery backup |
| Small cellar to Grade 3 | £8,000–£18,000 | Around 20–30 m² floor, membrane, sump, boarding |
| Annual sump service | from £150 | Pump and alarm tests, channel flushing |
What drives the price up or down
The single biggest factor is the grade of protection you need under BS 8102. A storage cellar that can tolerate a little dampness needs far less than a bedroom or home office, which must be completely dry. After that, cost follows the amount of detailing: every pipe, chimney breast, window well and doorway has to be sealed by hand, and a small cellar with lots of corners can cost more per square metre than a plain, open basement.
Old finishes matter too. Failed tanking, salt-laden render, bitumen paint and rotten timber all have to come off before anything new goes on. Access is the last big swing. Narrow cellar stairs, a single coal chute or no outside door mean every bag of waste and roll of membrane is carried by hand, which adds labour days.
- Grade of protection required, with habitable Grade 3 costing the most
- Total wall and floor area, ceiling height and number of corners and openings
- Gravity drainage to outside versus a pumped sump
- Condition of existing walls and how much has to be stripped
- Access for materials and waste removal
Membrane or tanking: how the choice affects cost
Tanking looks cheaper per square metre, but it relies on a perfect bond with a sound, well-prepared wall. On old brick or rubble stone that often means extra hacking off, render repairs and drying time before the slurry goes on, and the finish must then be plastered. A cavity drain membrane costs more to buy and fit, yet it tolerates uneven and salty walls and needs less preparation.
The hidden cost with membranes is drainage. Water collected behind the membrane has to go somewhere, and if the floor sits below the nearest drain you will need a sump and pumps. That adds a fixed sum regardless of cellar size, which is why small membrane jobs can look expensive per square metre.
Extra costs to budget for
Waterproofing makes a room dry; it does not make it a finished room. If you are converting a cellar into living space, the waterproofing is often less than half of the total. Insulation, a new floor build-up, electrics, lighting, ventilation and decoration all follow, and a habitable room also needs building control approval. Lowering the floor to gain headroom is a different scale of project, involving underpinning, structural design and often party wall notices.
- Battens or dry-lining boards over the membrane, and a floor screed or board
- Insulation, heating and mechanical ventilation for a habitable space
- Electrical work done to BS 7671
- Building control fees for a change of use to a habitable room
- Annual sump servicing from £150 a year
Ways to keep the cost down
The cheapest water is the water that never reaches the wall. Before committing to a full system, fix the simple outside causes: cracked gullies, leaking downpipes, blocked air bricks and flower beds or paths built up above the internal floor level. These repairs rarely cost much and can reduce the load on any waterproofing you do install, sometimes enough to change the grade or design needed.
Be clear about how you will use the space. If the cellar is only for bikes, tools and boxes, a Grade 2 design with a simpler finish may be all you need. You can also save by clearing the cellar yourself before the team arrives, so they are not paid to move belongings, and by planning sockets, shelving and radiators at design stage so nothing has to be reworked later.
- Repair gutters, gullies and downpipes first
- Lower outside ground levels where possible
- Match the BS 8102 grade to the real use of the room
- Empty the cellar before work starts
How to get an accurate price
Start with a survey rather than a phone estimate. A good surveyor takes moisture readings, looks for leaking drains, downpipes and high outside ground levels, checks whether gravity drainage is possible and measures every wall. Some damp problems turn out to be a cracked gully or a blocked air brick, and fixing that first can save thousands.
Ask for the written quote to name the system, the BS 8102 grade it is designed to achieve and exactly what is included up to the finished surface. A clear specification lets you compare quotes fairly. We arrange surveys with vetted, insured local specialists and you receive one all-in price for the work agreed.
Questions people also ask
Is basement waterproofing cheaper than an extension?
Usually, yes, per square metre gained. A cellar already has walls, a floor and a ceiling, so waterproofing and fitting it out often costs less than building new floor space above ground. The comparison changes if the floor must be lowered for headroom, because underpinning and structural work add significantly to the bill.
Why does a small cellar cost so much per square metre?
Small cellars carry the same fixed costs as large ones, such as the sump chamber, pumps, alarm and setting up on site. They also tend to have more corners, pipes and openings per square metre, each sealed by hand. Spread over a small area, those fixed costs push the per-metre figure up.
Is the survey fee refunded if I go ahead?
Many specialists credit the survey fee against the cost of the work if you proceed, but it varies. The report itself has value either way, because it identifies the cause of water ingress and the grade of protection needed. Ask at booking whether the fee is credited, so there are no surprises later.
Written and checked by the Basement Waterproofing team. Read our editorial policy.
More guides
Cavity Drain Membrane vs Tanking: Which Is Better for a Basement?
A cavity drain membrane is usually the better choice for old UK cellars because it collects water and drains it away instead of trying to hold it…
BS 8102 Explained: Basement Waterproofing Types and Grades
BS 8102:2022 is the British Standard code of practice for protecting below-ground structures from groundwater. It sets three types of protection:…
Converting a Cellar into a Habitable Room: What's Involved
Converting a cellar into a habitable room means waterproofing it to BS 8102 Grade 3, then insulating, ventilating, wiring and finishing it to…
Basement Sump Pump Maintenance: A Practical Guide
A basement sump pump should be professionally serviced once a year, from around £150. The engineer tests both pumps and the high-level alarm, cleans…
Get a free basement waterproofing quote
Tell us what you need and we'll come back with a clear price.
Request a quote