Basement Waterproofing glossary
The terms you'll come across, explained in plain English.
- Angle fillet
- A curved band of waterproof mortar formed where a wall meets the floor before tanking. It removes the sharp internal corner, which is a common weak point for leaks.
- Battery backup
- A battery unit that powers a sump pump when the mains supply fails, keeping the chamber emptying during power cuts, which often coincide with storms and heavy rain.
- BS 8102
- The British Standard code of practice for protecting below-ground structures against water from the ground. The 2022 edition sets out three types of protection and three grades of dryness.
- Cavity drain membrane
- A studded plastic sheet fixed to basement walls and floors that creates an air gap against the masonry. Water runs down behind it to a drainage channel instead of entering the room.
- Efflorescence
- White, powdery salt deposits left on masonry as water evaporates. It signals moisture moving through the wall and can stop coatings and plaster from bonding.
- Free lime
- Calcium compounds washed out of mortar and concrete by moving water. In drained systems it settles as white sludge in channels and sumps, so it must be flushed out regularly.
- Grade 3
- The BS 8102 grade for habitable spaces, where no water penetration or dampness is acceptable. It also expects ventilation, heating or dehumidification to control the internal environment.
- High-level alarm
- A sensor in the sump chamber that sounds a warning if water rises above the normal pumping level, signalling a pump failure, blockage or power problem.
- Hydrostatic pressure
- The pressure exerted by groundwater against basement walls and floors. It increases with the depth of water and is what pushes water through cracks and porous masonry.
- Inspection port
- An access point in the floor or channel that lets engineers flush and inspect the drainage system during servicing without lifting the finished floor.
- Perimeter drainage channel
- A plastic channel set into the floor around the edge of the basement. It carries water collected behind the membrane to the sump or a gravity outlet.
- Sump chamber
- A sealed pit set into the basement floor that collects water from the perimeter channels. It houses the pumps, float switches and alarm sensors of a drained system.
- Tanking
- A cement-based waterproof slurry applied in several coats to prepared masonry. It bonds to the wall and resists water pressure, but relies on a sound, stable substrate.
- Type A protection
- Barrier protection under BS 8102, where a coating or bonded membrane is applied to the structure to resist water. Cementitious tanking is the most common example in UK cellars.
- Type B protection
- Structurally integral protection, where the structure itself is designed to be watertight, usually using waterproof reinforced concrete. It is mainly used in new-build basements rather than existing cellars.
- Type C protection
- Drained protection, where water entering the structure is collected behind a membrane and channelled to a drain or sump pump, so it never reaches the internal space.
Get a free basement waterproofing quote
Tell us what you need and we'll come back with a clear price.
Request a quote